Skip to main content

ESAT FORMULA SHEET

ESAT formula sheet: every formula in the specification

The ESAT gives you no formula sheet. This page lists 83 formulae and results from the official specification for October 2026 and January 2027, each with its spec code and a clear label: 39 are written out in the specification, 36 are calculations it requires, 1 is provided in the test, 2 are explicitly not examined, and 5 are useful results it does not name.

83 formulae

  • M1Named in spec

    SI prefixes

    The eight prefixes listed at the start of the specification, used in every module.

  • M3.11Must be able to use

    Compound growth

    For decay, replace + with −.

  • M4.2Must be able to use

    Index laws

  • M4.5Named in spec

    Difference of two squares

  • M4.16Named in spec

    Quadratic formula

  • M4.16Must be able to use

    Completing the square

  • M4.19Must be able to use

    nth term of a linear sequence

  • M5.2Must be able to use

    Polygon angle sums

  • M5.7Named in spec

    Pythagoras’ theorem

    Used in both two and three dimensions.

  • M5.14Must be able to use

    Triangle, parallelogram and trapezium areas

  • M5.14Must be able to use

    Volume of a right prism

  • M5.15Named in spec

    Circle and cylinder

  • M5.15Given in the test

    Sphere, cone and pyramid

    The specification says these "will be given if needed": no need to memorise, but you must be able to use them.

  • M5.16Must be able to use

    Arc length and sector area (degrees)

  • M5.17Must be able to use

    Similar shapes

  • M5.18Named in spec

    Right-angled trigonometry

  • M5.18Named in spec

    Exact values

    Required: sin and cos of 0°, 30°, 45°, 60°, 90°, and tan of 0° to 60°.

  • M5.18Not examined

    Sine and cosine rules

    The specification says Mathematics 1 candidates are not expected to recall or use them. Mathematics 2 (MM4.1) does require them.

  • M6.2Must be able to use

    Frequency density

  • M6.3Must be able to use

    Grouped mean and IQR

  • M7.4Must be able to use

    Complementary events

  • M7.7Must be able to use

    Adding, multiplying and conditional probability

    Conditional probability is tested through two-way tables, tree diagrams and Venn diagrams; formal set notation is not expected.

  • MM1.1Must be able to use

    Rational exponents

  • MM1.2Must be able to use

    Rationalising the denominator

  • MM1.3Must be able to use

    Discriminant

  • MM1.6Must be able to use

    Factor and Remainder Theorems

  • MM2.2Must be able to use

    Arithmetic series

  • MM2.3Must be able to use

    Geometric series and sum to infinity

  • MM2.4Must be able to use

    Binomial expansion

  • MM3.1Named in spec

    Straight lines

  • MM3.1Useful, not named

    Midpoint and distance

    Not named in the specification; follows directly from Pythagoras and is used constantly.

  • MM3.2Named in spec

    Equation of a circle

  • MM4.1Named in spec

    Sine rule, cosine rule, triangle area

    Includes the ambiguous case of the sine rule; problems may be set in three dimensions.

  • MM4.2Must be able to use

    Radians: arc, sector, segment

  • MM4.5Named in spec

    Two trigonometric identities

  • MM5.2Named in spec

    Laws of logarithms

  • MM5.2Not examined

    Change of base

    The specification says questions requiring the change of base formula will not be set.

  • MM6.2Must be able to use

    Differentiating powers

    Differentiation from first principles is excluded; points of inflexion are not examined.

  • MM6.3Must be able to use

    Tangents, normals and stationary points

  • MM7.2Must be able to use

    Integrating powers

  • MM7.3Named in spec

    Fundamental Theorem of Calculus

  • MM7.5Must be able to use

    Trapezium rule

    You also need to say whether it over- or underestimates: it overestimates for a curve that bends upwards and underestimates for one that bends downwards.

  • MM8.2Named in spec

    Graph transformations

  • P1.2Named in spec

    Current

  • P1.2Named in spec

    Resistance

  • P1.2Named in spec

    Voltage

  • P1.2Named in spec

    Electrical power

  • P1.2Named in spec

    Energy transferred

  • P1.2Must be able to use

    Resistors in series

  • P1.2Useful, not named

    Resistors in parallel

    The specification only requires knowing that the total is less than any single resistor; this formula is not named but helps you check quickly.

  • P2.3Named in spec

    Force on a current-carrying wire

    For a straight wire at right angles to a uniform field.

  • P2.5Named in spec

    Transformers

    The second assumes 100% efficiency.

  • P3.1Named in spec

    Speed, velocity and acceleration

  • P3.1Named in spec

    Equation of motion

    This is the only equation of motion the specification names; the rest come from gradients and areas of v–t graphs.

  • P3.1Useful, not named

    Other constant-acceleration equations

    Not named in the specification; each follows from a v–t graph, where the gradient is acceleration and the area is displacement.

  • P3.3Named in spec

    Hooke’s law and stored energy

  • P3.4Named in spec

    Newton’s second law

  • P3.5Named in spec

    Weight

  • P3.6Named in spec

    Momentum

  • P3.7Named in spec

    Work, GPE and KE

  • P3.7Named in spec

    Power and efficiency

  • P4.4Named in spec

    Specific heat capacity

    Temperature in °C; c in J kg⁻¹ °C⁻¹.

  • P5.2Named in spec

    Gas at constant temperature

  • P5.3Must be able to use

    Specific latent heat

  • P5.4Named in spec

    Density

  • P5.5Named in spec

    Pressure and hydrostatic pressure

  • P6.1Named in spec

    Frequency and wave speed

  • P6.3Named in spec

    Law of reflection

  • P6.4Named in spec

    Range of human hearing

  • P7.2Must be able to use

    Effect of decay on A and Z

  • P7.4Useful, not named

    Half-life

    Half-life calculations are required; this expression is not named, and for whole numbers of half-lives simply halving repeatedly is faster.

  • C4.2Must be able to use

    Number of particles

  • C4.3Must be able to use

    Moles

    Watch conversions between tonnes, kilograms and grams.

  • C4.4Must be able to use

    Percentage composition by mass

  • C4.8Named in spec

    Molar gas volume

  • C4.9Must be able to use

    Concentration

  • C4.10Must be able to use

    Titration

  • C4.11Named in spec

    Percentage yield

  • C8.3Must be able to use

    Rf value

  • C9.1Named in spec

    pH and H⁺ concentration

  • C11.4Must be able to use

    Calorimetry

  • C11.5Must be able to use

    Energy change from bond energies

    Bond breaking is endothermic; bond formation is exothermic.

  • B9.2Useful, not named

    Surface area to volume ratio

    The Biology specification has almost no formulae; this one explains why exchange surfaces matter as organisms grow. Biology also assumes all of Mathematics 1.

Source: UAT-UK, ESAT Content Specification (October 2026 and January 2027). Every module also assumes the content of Mathematics 1.

How to use it

Memorise the named ones, practise the rest

  • Start with the formulae marked "Named in spec": the specification writes these out, so expect them to be needed without a prompt.

  • For "Must be able to use", the specification requires the calculation but does not print the formula. Learn the standard form shown here.

  • Do not spend time memorising anything marked "Given in the test" or "Not examined". Knowing what you can skip is part of the value of this table.

  • The ESAT allows 40 minutes for 27 questions per module, about 89 seconds each, and no calculator. Recall has to be instant, so practise with timed questions rather than rereading the list.

FAQ

Common questions

Is there a formula sheet in the ESAT?
No general formula sheet is provided. The specification lists the formulae you are expected to know. The one stated exception is in Mathematics 1: formulae for spheres, pyramids and cones will be given if needed.
Do I need the sine and cosine rules for the ESAT?
Only for Mathematics 2. The specification says Mathematics 1 candidates are not expected to recall or use the sine or cosine rules; Mathematics 2 (MM4.1) includes them, along with the area formula ½ab sin C.
Which equations of motion are in the ESAT Physics specification?
Only v² − u² = 2as is named. The other constant-acceleration results can be read from velocity–time graphs, where the gradient is acceleration and the area is displacement, which the specification does require.
Is the change of base formula for logarithms examined?
No. The Mathematics 2 specification states that questions requiring knowledge of the change of base formula will not be set.
What value of g should I use?
The Physics specification says gravitational field strength is approximated as 10 N kg⁻¹ on Earth.

UAT-UK, Pearson, OCR, the University of Cambridge, Imperial College London and other names and logos belong to their respective owners.

Practise recall against the clock

ESAT-style questions by module and topic, with worked solutions. Free to start.